WBPEEUI240751C0 PR8 - 1
PR8
AIN-220 Setup
Purpose/Scope
This procedure gives the steps required to set up the AIN-220
block for proper operation. This includes setting jumpers and
switches, and checking for fuses.
Prerequisites
• Completed worksheet WS3.
Parts
None.
To o l s
• Small-tipped, flat-blade screwdriver.
• Needlenose pliers (optional).
Safety Considerations
Procedure
□
1. Set the special operations switch SW2 located on the back
of the I/O module to normal operation.
□
2. Determine the block field power and I/O channel require-
ments. Refer to the appropriate worksheet or any other system
documentation available.
□
3. Set the field power select jumpers J1 and J2 located on the
back of the I/O module (Table PR8-1).
15 min.
CAUTION
1. For analog input channels, if the fused AI IFP/LFP option is
selected to power a 4 to 20 milliampere input, removing the I/O
module from the base in nonredundant applications will result
in a loss of power to all input current loops.
87654321
ON
OFF
T00884A
To Next Page
Loading...
