Operation Manual / TPL65VA32/33
Page 50
© Copyright 2015 ABB. All rights reserved.
September 2015 HZTL2464_EN Revision C
If the speed sensor is not fitted on the turbocharger, the following
procedure must be adopted to fit it:
Engine and turbocharger are not running.
The turbocharger lubricating system is switched off.
Remove screw plug (42047) from bearing casing.
The position of the screw plug for measuring the speed is marked "
"
on the bearing casing.
Screw in speed sensor (86505) as far as it will go and tighten to torque
specified in table. (See chapter Table of tightening torques.)
Connect speed sensor using cable connector (86515).
To Next Page
Loading...
