Operation Manual / TPL65VA32/33
Page 87
© Copyright 2015 ABB. All rights reserved.
September 2015 HZTL2464_EN Revision C
Turn the compressor casing (72000) together with the wall insert and
diffuser and set them down with surface (
) on an underlay.
Tipping the compressor casing
Make sure the underlay does not shift.
Allow the compressor casing to rest only on surface (
).
Check the underlay and adjust it if necessary.
Remove the screws (72002).
Remove the diffuser (79000).
Remove the wall insert (77000) using swivel lifting eyes (90235).
Remove the O-ring (77005) from the wall insert.