ABB TPL65VA33 - Page 99

Operation Manual / TPL65VA32/33
Disassembly and assembly
8
Installing cartridge group
8.9
Page 97
© Copyright 2015 ABB. All rights reserved.
September 2015 HZTL2464_EN Revision C
 Measure and note the axial clearance (
A
) (see the section on axial
clearance).
CAUTION
Clearances out of tolerance
Clearances out of tolerance and excessively worn components can be
the cause of serious damage to machinery and property.
 Have components assessed and, if necessary, replaced by an ABB
Turbocharging Service Station.
 Connect oil pipes and all air lines in accordance with engine builder’s
instructions.
Version with compressor wheel cooling system
 Fit the air supply line. (Also see the chapter Preliminary remarks /
Layout and functioning.)
 Fit the filter silencer or air suction branch.
 Fit the insulation.