Operation Manual / TPS48-D/E.. - TPS61-D/E..
Turbine cleaning during operation
Page 61
April 2015 HZTL2410_EN Revision D
The interval between periodic cleaning is very dependent on the operating
conditions. In general, cleaning should be carried out every 50 to 200
operating hours.
Should the specified cleaning intervals prove incompatible with engine
operation, please contact ABB Turbo Systems.
Turbine components are cleaned during operation using the wet cleaning
processes described in the following. These have been tested and are
approved by ABB Turbo Systems.
The turbine casing design and the type of turbine casing sealing are
decisive for the choice of cleaning method.
Approval by engine manufacturer
The prerequisite for wet cleaning is that the engine manufacturer
approves the method and his instructions are followed.
© Copyright 2015 ABB. All rights reserved.
To Next Page
Loading...
