What to do if ABB Switch-disconnector will not close or open?
If your ABB Switch-disconnector won't close or open, verify that the switch is not in the earthed position and the interlocking selector is in the ‘Operation’ position. Also, ensure the auxiliary power supply is connected.
Why ABB Uniswitch-disconnector cannot be opened?
If the ABB Switch-disconnector cannot be opened, ensure that the switch is in the closed position and the interlocking selector is in the ‘Operation’ position. Try turning the operating handle anti-clockwise.
Why ABB Switch-disconnector cannot be closed?
If the ABB Switch-disconnector cannot be closed, make sure the switch is in the open position and the interlocking selector is in the ‘Operation’ position. Then, turn the operating handle clockwise.
What to do if ABB cable compartment door will not open?
If the ABB cable compartment door won't open, check that the switch is in the earthed position and the interlocking selector is in the ‘Door open’ position. Also, remove the key from the circuit-breaker before opening or closing the door.
What to do if ABB circuit-breaker will not go to the closed position?
If the ABB circuit-breaker won't go to the closed position: 1. Ensure that the closing spring is fully charged and that the interlocking coil is not energised. 2. Check that the circuit-breaker key is in place and turned to the correct operating position. 3. Verify that the circuit-breakers auxiliary voltage plug is properly locked into the socket. 4. Check that the control pin is on its position (HAD- US).
Why ABB Uniswitch Switch-disconnector cannot be moved to the earthed position?
If the ABB Switch-disconnector cannot be moved to the earthed position, ensure that the switch is in the open position and the interlocking selector is in the ‘Test’ position. Turn the operating handle clockwise.
What to do if ABB Uniswitch Switch-fuse will not close?
If the ABB switch is in the open position because of a fuse trip or motor operation, turn the notch on the operating shaft downwards before operating the switch to the closed position. Also, check if a fuse has blown.
How to fix secondary measurements from the current transformers if they are not possible on ABB?
If secondary measurements from the current transformers are not possible on your ABB device, check that all shorting links on the secondary terminals of the current transformers have been removed and verify the connections.
Provides detailed electrical specifications like voltage, current, and IP ratings.
Specifies the system's resistance to internal arc faults and relevant standards.
Explains the purpose and types of interlocking devices for safety and correct operation.
Provides essential safety precautions and warnings before operating the switchgear.
Outlines the steps for commissioning the switchgear before connecting to power.
Manual operations for withdrawable type switchgear, including insertion and withdrawal.
Safety precautions to be observed before performing maintenance.
Common problems and their corresponding solutions for all cubicle types.
To Next Page
General
