5-8
Questions? Refer to Page 10-9 For Technical Support Instructions.
Chapter 5: Data Review
1. Press 6 to select Linearity Data.
The monitor shows linearity tests first by level
(1, 2, 3, 4, 5) then by order within each level. If
no tests are stored for a level, then that level is
skipped. At the top of the display the level
(1 through 5) and test replicate (1 through 4)
are displayed.
2. You can select one of the following options:
Press 1 – Previous
Press 2 – Next
When finished reviewing the data,
you can:
Press Clear to return to the
Data Review screen.
Press Menu to return to the
Menu Mode menu.
Press On/Off to turn off the monitor.
The number that appears to the right of
1-Previous and 2-Next on the monitor
indicates the number of tests available for
review. The display shows the following:
Comment Code (Number in box)
Level (1, 2, 3, 4, or 5)
Test Type (Glucose)
Date and Time of test
Operator ID (o: prompt)
Note that test date and time alternates with
Operator ID.
What You See on the Display What You Do Comments
Data Review for Linearity Data
The monitor stores the last linearity panel that includes a maximum of 4 replicates for 5 levels (20 tests). Please refer to
the beginning of this Data Review chapter for step-by-step instructions to access the Data Review menu.
Note: The following section illustrates some common settings. Depending on your institution's specific settings,
some screens will display differently or not at all. If the monitor does not display the screens shown, please
refer to Chapter 10, Troubleshooting.
2.5 mmol/L
To Next Page
Loading...
Need help?
General
