8-3
Questions? Refer to Page 10-9 For Technical Support Instructions.
1. P r e s s On/Off to turn on the monitor.
The Abbott logo screen will appear in black for
a few seconds and then will appear in gray to
ensure that the display is functioning properly.
Next, the software version and then the Test
Mode menu screens will appear.
2. Press the Menu button. The monitor starts in Test Mode. The Menu
button will toggle the monitor to Menu Mode.
3. P r e s s 2 to select Review Setup.
What You See on the Display What You Do Comments
Note: This section illustrates some representative settings.
If the monitor does not display these screens, please refer to Chapter 10, Troubleshooting.
Review Setup
Chapter 8: Review Setup
To Next Page
Loading...
Need help?
General
