8-8
Questions? Refer to Page 10-9 For Technical Support Instructions.
What You See on the Display What You Do Comments
Review Test Setup for Security
Chapter 8: Review Setup
Note: This section illustrates some representative settings.
If the monitor does not display these screens, please refer to Chapter 10, Troubleshooting.
1. Press 1 for Test Setup.
2. P r e s s 5 for Security to continue to the
Security QC Interval screen.
3. P r e s s 1-Next to continue to the
Security Operator ID Not Certified
screen.
4. P r e s s 1-Next to continue to the
Security Strip Lot Not on List screen.
5. P r e s s 1-Next to continue to the
Security Patient Data Not Confirmed
screen.
6. P r e s s 1-Next to continue to the
Security Confirm Patient Data screen.
7. P r e s s 1-Next to return to the
Test Setup menu.
To Next Page
Loading...
