Once the test results have been collected during a prescribed period of time, they can be uploaded into the
data management system. The data management system provides a simple and automated way to collect, report and
transfer data.
To start the upload of data, simply place the Precision Xceed Pro Monitor into the docking station. The monitor will first
turn on if it isn't already, and then automatically upload data to the data management system. After upload is complete,
the monitor will display Upload Successful, Turning Off and then shut down.
During communications, this screen appears and the arrows rotate to indicate that
the system is working. The arrows may occasionally pause. During data upload, the
monitor cannot be used for testing.
Note: If the monitor is removed before data transmission is complete, some data may not be uploaded.
The data will be uploaded as part of the next data transmission.
If a problem occurs with the data upload, an error message may appear on the monitor. If the monitor is removed from
the docking station while an upload is in process, the monitor will display Last upload incomplete, Redock meter,
Turning Off. The monitor will then shut down. Error messages are shown in Chapter 10 Troubleshooting chapter.
Further troubleshooting information for any data upload question is provided in the data management user manual.
After a data upload error has occurred, the monitor will display a warning each time
it is turned on. The monitor may still be used for testing by pressing 1 to Continue.
Once the monitor has successfully been docked, the warning will disappear.
Data Upload
9-1
Questions? Refer to Page 10-9 For Technical Support Instructions. Chapter 9: Data Upload
To Next Page
Loading...
Need help?
General
