Abit BH6 - Processor Number Feature; Video Bios Shadow

Introduction of BIOS 3-15
Processor Number Feature:
This feature can let the program read the data inside your processor. This
feature only works with Intel
®
Pentium
®
III processors. When you install a
Pentium
®
III processor into your motherboard, and when your system
boots-up then this item will show up in BIOS.
Two items will be available: Enabled and Disabled. When you choose
Enabled, the specific program can read your processor's serial number.
When you choose Disabled it will not allow the program to read your
processor's serial number. The default setting is Disabled.
Video BIOS Shadow:
This option is used to define whether the BIOS on the video card uses
shadow feature or not. You should set this option to Enable, otherwise the
display performance of the system will greatly decrease.
Shadowing address ranges (C8000-CBFFF Shadow):
This option allows you to decide if the memory block (BIOS) of an
interface card at the address C8000-CBFFF uses the shadow feature or not.
If you have no interface card using this memory block, don’t enable this
option.
Shadowing address ranges (CC000-CFFFF Shadow):
This option allows you to decide if the memory block (BIOS) of an
interface card at the address CC000-CFFFF uses the shadow feature or not.
If you have no interface card using this memory block, don’t enable this
option.
Shadowing address ranges (D0000-D3FFF Shadow):
This option allows you to decide if the memory block (BIOS) of an
interface card at the address D0000-D3FFF uses the shadow feature or not.
If you have no interface card using this memory block, don’t enable this
option.
Shadowing address ranges (D4000-D7FFF Shadow):
This option allows you to decide if the memory block (BIOS) of an
interface card at the address D4000-D7FFF uses the shadow feature or not.
If you have no interface card using this memory block, don’t enable this
option.