ABL eMH1 Installation And Operating Manual

INTRODUCTION
6
COMPONENT QUANTITY DESCRIPTION
Drilling template 1 Template for drilling the holes for wall mounting
Installation kit 1
S
et of fixings for wall mounting, consisting of 5 x 60
screws as well as matching wall plugs 8 x 40, 6 seal-
ing grommets for openings at the wall bracket
Should one or more components be missing after unpacking, please contact your local
distributor immediately: You can find the necessary contact details on page ii in
this manual.
Available accessories
ABL sells additional accessories for your eMH1 Wallbox. For the models of the EVSE
803 and 813 series, the following components are available:
DESIGNATION MODEL NUMBER QUANTITY
Mounting pole*
For mounting all eMH1 Wallbox mod-
els with or without bracket
Dimensions: 1600 x 280 x 70 cm
Weight: 2,000 g
* does not include the wallbox pictured
STEMH10 1
Please contact your local distributor if you require additional information about these
components or would like to place an order.
WARNING!
Please note that the do-it-yourself installation of accessory components is
not permitted: Please contact a qualified contractor or arrange installation
with your local distributor .
Please also visit our website at ...
www.abl.de
You will find further information about our products and our entire range there.

ABL eMH1 Specifications

General

Model	eMH1
Category	Battery Charger
Charging Power	3.7 kW
Connector Type	Type 2
Protection Class	IP54
Operating Temperature	-25°C to +40°C
Charging Current	16 A
Input Voltage	230 V