Ableton Push 3 User Manual

enabled, Push treats the chosen length as a musical phrase, and will
begin recording from the position in the clip that corresponds to that
position within a phrase of that length. For example, with a fixed length
of 4 bars and Phrase Sync on, starting a recording when transport is at
bar 7 will create an empty four bar clip and begin recording at the third
bar of that clip.
Tip: Enabling Fixed Length while recording will switch recording off and
loop the last few bars of the clip, depending on the Fixed Length
setting.
8.3 Recording with Repeat
Pressing the Repeat button enables the Repeat Intervals buttons, which
are used to set the repeat rate for notes. The Repeat button will pulse
when active, and the button with the currently selected repeat interval
will be lit up in green.
7/29/23, 9:32 AM
Page 118 of 193

Ableton Push 3 Specifications

General

Type	MIDI Controller / Standalone Instrument
Standalone Mode	Yes
Sample Rate	Up to 96 kHz
Bit Depth	24-bit
Pads	64
Display	Full-color
Connectivity	USB, MIDI I/O
Power	external power supply
Storage	Internal SSD
Software	Ableton Live
Compatibility	Ableton Live 11.3 or later
Processor	Intel-based processor (specific model not disclosed)