Hold a Step in Clip Mode to View Note Parameters.
You may notice that the parameters are slightly different when editing
steps than when editing notes individually.
To adjust these parameters for multiple steps at the same time, press
and hold all of the steps you’d like to adjust, and then tweak the
encoders. Note that if the parameter values are different for the
selected steps a range of values for the selected steps will be shown in
the display.
When working in the drum sequencer, you can adjust parameters for all
steps belonging to a single drum pad. To do this, press and hold the
Select button, press and hold the pad, release the Select button and
adjust the relevant encoders.
To Next Page
Loading...