You can also Flatten a frozen track to replace the original clips and
devices with the referenced sample files by holding the Shift button
and pressing the track’s lower display button, then selecting Flatten.
12.2 Using CV to Control Modular Synthesizers
Push can be used to control and record audio from CV-enabled
instruments, such as modular synthesizers. To do this, you can use
presets from the pre-installed CV Tools Intro Pack.
First you will need to enable CV Out, which by default is switched off to
limit the risk of damaging gear that is not meant to be connected to the
Pedal 1 and 2 ports, such as headphones or speakers.
Press the Setup button and then the Pedals & CV tab. Here you can use
the corresponding encoders to switch on CV Output for one or both
ports.
Enable CV Out.
Each Pedal jack is stereo and can be used with a male TRS to dual
female TS splitter cable to access a total of four CV outputs.
When using CV, Pedal 1 represents outputs 5 and 6 on Push, while
Pedal 2 represents outputs 7 and 8.
Once CV Out is enabled and you have connected your splitter cable to
your CV inputs and Push’s Pedal jacks, you can set up a MIDI track with
To Next Page
Loading...
Need help?
General
