Display of the resolution of the current stream
Display of the current connection status
Direct:
The Peer2Peer server was able to establish a direct connection between your
device and the camera.
Relay server*:
The Peer2Peer server could not establish a direct connection. The video data
is stored for a short time on the relay server so that your device can obtain the
data from the server. This causes a delay in the stream.
Display of the current assessment of the connection
This is the connection between the base station and the router.
Display of currently consumed kilobits per second
*Note
If the connection to your camera is always made via the relay server, please check the
following settings:
• Check if UPnP is enabled in your router
• Check whether a hardware firewall or software firewall denies a direct connection
• Check whether several "hops" (routers) are installed between the terminal device
and the Internet.
To Next Page
Loading...
