To Next Page

To Previous Page

PROGRAMMING

AUTO MODE (LOW TEMPERATURE TRIGGER)

Pressing the up or down button sets the low

temperature trigger. The fans will activate if the

probe’s reading meets or falls below this threshold.

Once triggered, the fan will gradually ramp up to the

speed set in ON mode. If the probe’s reading rises

above this trigger point, the fans will gradually slow

down to a stop or at the speed set in OFF mode.

You may set this trigger above the high temperature

trigger to create a specific range in which the fan

is active.

AUTO MODE (HIGH HUMIDITY TRIGGER)

Pressing the up or down button sets the high

humidity trigger. The fans will activate if the probe’s

reading meets or exceeds this threshold.

Once triggered, the fan will gradually ramp up to the

speed set in ON mode. If the probe’s reading falls

below this trigger point, the fans will gradually slow

down to a stop or at the speed set in OFF mode.

You may set this trigger below the low humidity

trigger to create a specific range in which the fan

is active.

Note that this trigger can activate as long

as you are in AUTO Mode, even if you are

viewing a different trigger within AUTO Mode.

If there is a speed set in OFF Mode other

than zero, the fans will run at that speed when

triggered to turn off.