Access RAD ASMi-54 - Configuring SHDSL PME Margin Settings

Installation and Operation Manual Chapter 4 Configuration
ASMi-54 Ver. 1.0 Configuring for Operation 4-15
Parameter Possible Values Remarks
SNR Margin
Threshold (dB)
0…15 The SNR margin alarm threshold.
Default: 0
Configuring the SHDSL PME Current Margin
Only available in STU-R mode.
 To configure the SHDSL PME current margin:
1. Select Main Menu>Configuration>Physical Layer>SHDSL>PME Configuration.
The SHDSL PME Port Configuration screen appears (see
Figure 4-17 ).
2. Select Current Margin.
The SHDSL PME Current Margin screen appears (see
Figure 4-18 ).
3. Select an item (1-32).
4. Press <S> to save the changes.
Configuring the SHDSL PME Worst Margin
Only available in STU-R mode.
 To configure the SHDSL PME worst margin:
1. Select Main Menu>Configuration>Physical Layer>SHDSL>PME Configuration.
The SHDSL PME Port Configuration screen appears (see
Figure 4-17 ).
2. Select Worst Margin.
The SHDSL PME Worst Margin screen appears (see
Figure 4-18 ).
3. Select an item (1-32).
4. Press <S> to save the changes.
Note
Note