115
Technical Information
10
Electromagnetic Compatibility – This meter meets the electromagnetic immunity requirements as
per ISO15197. The chosen basis for electrostatic discharge immunity testing was basic standard
IEC61000‑4‑2. In addition, the meter meets the electromagnetic emissions requirements as per
EN61326. The meter’s electromagnetic emission is thus low. Interference from the meter to other
electrically‑driven equipment is not anticipated.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired
operation.
This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled
environment. This equipment is in direct contact with the body of the user under normal operating
conditions. This transmitter must not be co‑located or operating in conjunction with any other antenna or
transmitter.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance (i.e. the
manufacturer) could void the user’s authority to operate the equipment.
54988_08100918001_EN.indb 115 9/30/16 5:04 PM
To Next Page
Loading...
Need help?
General
