SwitchSpeed™ Controller Manual V1.3 © 2009 AccuAir Control Systems, L.L.C.
- Page 11 -
Resetting DEFAULT Settings:
Restoring the DEFAULT Pulse Time Settings:
With the Ignition ON hold the Program “ ”
Button & Speed #1 “ ” Button for 5 seconds
until all of the Speed Indicators strobe up and
down. This will Restore the SwitchSpeed™ to
the DEFAULT Pulse ON / OFF Times.
Selecting ALL-DOWN Mode Type:
Change ALL-DOWN Mode To
TIMER or MOMEMTARY:
With the Ignition ON, press the Program “ ”
Button. Next press the #3 UP “ ” Button to
turn ALL-DOWN Mode to TIMER and the
#4 UP “ ” Button to turn ALL-DOWN Mode to
MOMENTARY.
When the #3 UP “ ” Arrow is White:
ALL-DOWN Mode is TIMER.
When the #4 UP “ ” Arrow is Red:
ALL-DOWN Mode is MOMENTARY.
NOTE: Program Mode will exit after 5 seconds
or can be exited by pressing the Program Button
again and your changes will be saved.
Setup Programming:
To Next Page
Loading...