Now your system components are installed, plumbed, and wired (Mechanical Air
Suspension Components, Compressor(s), Tank(s), Tank Pressure Sensor, Valves,
Air Line, ECU, and SwitchSpeed™ Controller), it is time to test the system.
To Begin Testing The System:
Turn the vehicle Ignition ON, or start the vehicle.
(You will need to be charging your electrical
system either by running the vehicle or by using a
high amperage battery charger).
As you consume air pressure by raising the vehicle,
the Air Compressor(s) will automatically turn ON
when necessary.
This is a good time to do some mechanical system
checking:
Look for mechanical interference throughout the
range of travel for the Air Springs and all moving
suspension components.
Test for air leaks at all ttings and pipe threaded
joints using a soapy spray bottle. To x any air leaks
rst lower the Air Springs, then turn the Ignition OFF
and depressurize the Air Storage Tank(s).
Testing Wiring & Mechanical Components:
To Next Page
Loading...
Need help?
General
