AccuTemp Evolution - Page 27

SP8026-1909
EVOLUTION ELECTRIC STEAMER
27
PROGRAMMING EXAMPLE
To adjust the HOLD temperature on the steamer - use the follow instructions:
1. Depress S4 (down arrow) & S6 (Temp display) buttons at the same time and hold for eight
seconds.
2. After 8 seconds, the Hrs LED light will blink and 180F will appear on the display. Release S4 and
S6.
3. Press the S3 (cook/hold) or S6 (TEMP display) to alter the HOLD temp.
4. Press S2 to save the input
To adjust the TIMER on the steamer - use the following instructions:
1. Depress S4 (down arrow) & S6 (Temp display) buttons at the same time and hold for eight
seconds.
2. After 8 seconds, the Hrs LED light will blink and 180F will appear on the display. Release S4 and
S6.
3. Press S1 (up arrow) once to access ‘default timer value = hours’. Press either S3 (cook/hold) or
S6 (temp display) to increase or decrease the number of hours.
4. Press S1 again to access ‘default timer value = minutes’. Press either S3 (cook/hold) or S6 (temp
display) to increase or decrease the number of minutes.
5. Press S2 to save the input.
To exit without saving push S5 (power).