9
C. “Timer/Clean” button: Press this button once quickly to enter the timer setting program; press
and hold this button for more than 5 seconds to let the device enter the self-cleaning program.
D. Switch buttons: ON/OFF
E&F. “ - “, “ + “ buttons:
This is used to adjust the duration of the ice making process. The default setting is 0. Each time
the "+" or "-" button is pressed, it increases or decreases by 1 minute.
In addition, the delay time of the timer can be adjusted; the default setting is 0. Each press of the
"+" or "-" button increases or decreases the time by 1 hour.
Installation Steps
Unpack the Ice Machine
1. Remove the outer and inner packaging. Check that all accessories, including instruction
manual, ice scoop, white water inlet tube, 4-way to 2-way quick connector and drain tube,
etc., are inside the package. If any parts are missing, please contact our customer service.
2. Remove the tape used to secure the door and inner cabinet, ice scoop, etc., and roughly
clean the inner cabinet and ice scoop with a damp towel.
3. Place the ice machine on a flat surface away from direct sunlight and other heat sources
(e.g.: stove, stove, radiator). Make sure there is a minimum distance of 8 inches between the
air outlet and the obstruction, and at least 2 inches between the left and right sides and the
wall.
4. As the ice machine may be upside down during shipping or shipping, wait 4 hours for the
refrigerant to settle before inserting the ice machine.
5. Electrical appliances must be placed where the plug can be reached.
WARNING: Only connect to a potable water supply and use potable water only.
Installation Location Requirements
a. This product is not suitable for outdoor use. Maintain proper room temperature and inlet
water temperature according to the above specification sheet. Otherwise, the ice making
performance will be affected.
To Next Page
Loading...