1. After connecting the main water supply hose to the device, plug in the main power plug.
Then press the On/Off button on the control panel to start the ice making cycle. The On/Off
status symbol will remain illuminated; the number on the left in the LCD display window
shows the current ambient temperature, the number on the right shows the current ice
making setting, and the ice cube symbol rotates. When the number on the left flashes, the
number indicates the countdown time to complete an ice making cycle.
2. Each ice making cycle will last about 11 to 20 minutes, depending on ambient temperature
and water temperature. When making ice for the first time, the duration of ice making will
be slightly longer depending on the initial water temperature.
3. After the ice making process is over, switch to the ice harvesting process. During the ice
extraction process, the ice cube symbol will flash and rotate. At the same time, the arrow on
the water addition symbol starts to flash, and the water will flow into the water tank again
until the float of the water level switch rises to the highest position. Then, the water stops
flowing, and the entire manual water addition symbol disappears.
After the ice harvest is completed, the “full ice” detection plate will rotate down once, and
then return to the original position to enter the next ice making process.
If the full ice detection plate is rotated and cannot be returned to its original position due
to being squeezed by the ice cubes, it means that the ice cubes in the ice storage bin are full and
the ice making will be stopped automatically.
4. When the "ice full" symbol display turns on, the unit stops running. If you remove the ice
cubes, the device will restart making ice cubes after three minutes.
5. During the ice making process, press the "+" or "-" button to adjust the length of each ice
making cycle to change the thickness of the ice cubes. Press the "+" or "-" button, the
number on the right will flash, the default setting is zero, and each time the "+" or "-" button
is pressed, each ice making cycle will increase or decrease by 1 minute. After 5 seconds of
setting, the new setting will be remembered by the system.
Note: Poor water quality will lead to poor ice quality and reduce the transparency of the
ice.
Automatic Self-Cleaning Program
Start the self-cleaning program: After connecting all the water pipes, plug in the main power plug,
and then press the "Timer/Cleaning" button on the control panel for more than 5 seconds to
To Next Page
Loading...