Internal LED light operation
When the machine is powered on, press the "light" button on the operation panel once; the LED
light in the freezer will illuminate, and the " " symbol on the LCD display window will also turn
on.
Pressing the button again will cause the LED light and the " " symbol will go out at the same
time.
Note: If you press the "LIGHT" button for more than 5 seconds, you can switch between Celsius
and Fahrenheit (between °C and °F).
Drain
First, make sure the drain hose is properly connected to the rear of the unit.
1. You can drain the water in the freezer through the white drain pipe attached to the rear
drain. Make sure not to set the white drain pipe too high.
2. For the water in the water tank, you can remove the silicone tube marked "H" on the right
side of the water tank in Figure 3 to drain the clean water in the water tank, until the
silicone tube is fully extended, and the water can flow out into the freezer. The water can
then drain through the drain on the rear of the unit.
Reminder: Frequent cleaning of the water tank can improve the quality of ice cubes and
prolong the service life of the equipment and its circulating water pump.
Normal Sound
Your new ice machine may be making unfamiliar sounds. Most of the new sounds are normal.
Hard surfaces like floors, walls, and cabinets can make things sound louder than they really are.
Here are some of the kinds of sounds you might find strange.
For each ice cycle, you will hear a swishing sound as the control valve opens to allow water
to flow into the tank.
A rattling noise may emanate from the flow of refrigerant or from the water pipes. Items