Acer Altos EasyStore - Stopping a Backup or Recovery in Progress

Altos eas
y
Store Manua
l
Chapter
5 Protecting Local Disks
117
Stopping a backup or recovery in progress
Once a backup or recovery starts , you can stop it at any time—for example , if you
notice
that your system is no t responding as quickly as you’d like, and you want to
free
up processing capabilities for o t her t asks.
When you stop a backup in progress, t hat backup won’t appear in the list of
backups
on the Restore page , and any changed data that was not copied to the
storage
system will be copied during the next backup.
When you stop a recovery in progress, the local disk or partition is lef t in an
incomplete
state, and you must recover it again later before you can use it.
To stop a backup or recovery in progress:
1. Click Status .
2 . In the Protected di sk list, select the disk whose backup or recovery you want to
stop.
3. Click Stop Current Activity .
If you’re stopping a backup, the backup stops immediately .
If you’re stopping a recovery , a confirmation message displays. Click OK to stop
the
recovery now , or click Cancel to proceed with it.