Acer Altos EasyStore - Page 132

Altos eas
y
Store Manua
l
Chapter
5 Protecting Local Disks
125
4. Click Enable .
A message displays, advising you t hat your network connection will be
temporarily
interrupted.
5. Click Yes to allow t he temporary network interruption. (Your network connection
will
be restored immediately a f ter this process is complete.)
On the Enable Remote Boot dialog box, the Details area shows the progress of
the
enabling process. If any problems are encountered—for example, if the
selected
disk or partition was not your system disk—that portion of the process
is marked as Failed . You can click the plus sign next to the process description
to expand it and display an error message tha t explains exactly what happened.
6 . When a message displays, advising you that drivers will be installed, click OK .
7 . When the drivers are installed , one or more messages migh t appear , advising
you
tha t these drivers are no t signed. This has no adverse effect on your
system. Click Continue Anyway or Yes on each message to proceed with the
installation
.
In addition, t he Found New Hardware Wizard starts . Select No, Not This T i me
on the initial screen and complete the rest of the wizard , accepting all the default
values.
If remote boot was successfully enabled (as indicated in the Details area), a
new
backup is created automatically .
Note: If remote boo t was successfully enabled but for some reason the
new backup was not created (as indicated in the Details area), you must perform
a
manual backup (as described in “Manually backing up your disk” on
page 116) . You can remotely boo t only from backups that were performed
after
remote boot was enabled.
8. Click Close .
If no problems were encountered, you can now remotely boot f rom the storage
system
(as described in “Recovering a system disk while booting remotely”).
If any problems were encountered , t ake corrective action . For example, if you
did not previously protect a system disk or partition, do so now (as described in
“Protecting
your disks”). Then repeat this procedure for enabling remote boot until
all parts of the process complete successfully .