Acer Altos EasyStore - Page 17

Altos eas
y
Store Manua
l
10
Chapter
2 Getting Started
10
Note: If you connect a storage system to the network a f ter the Console has
already scanned it, or if you subsequently change the IP address of the
storage
system, you must click Discover Storage Systems to scan the
network
again and update the tree in the lef t pane.
If no storage system displays in the lef t pane, your compu t er might no t be in
the
same subnet as the storage system. Be sure to install the Console on a
compu
t er in the same subnet as the storage system and try again.
2 . In the le ft pane , select the name o f the storage system that you want to access
(for example , Storage ), and then click Log On Storage System Manager .
If your storage system uses both available ports to connect to the network, you
can
select either item .
3 . If your storage system has not yet been initialized, the System Initialization
page displays. For more information, refer to the next section, “Initializing the
disks.”
If your storage system been initialized but no t yet configured, the welcome page for
the System Setup Wizard displays. For more information, refer to
“Configuring your storage system” .
If your storage system has been initialized and configured, the login page for the
Manager
displays. For more information, refer to “Logging in to the Manager”.