Machine Maintenance Procedures 3-41
4. Move along side edges until bezel is separated from LCD cover.
5. Remove bezel.
LCD Bezel Installation 0
1. Align hinges side of bezel to LCD cover and press down until there is no gap between
bezel and LCD module.
Make sure cables do not get caught underneath bezel, it may cause damage to
cables.
2. Install and secure screws (A) to LCD cover (Figure 3-42).
3. Install screw caps (A).
4. Install LCD module.
ID Size Quantity Screw Type
E M2.5x6 Ni 2
To Next Page
Loading...
