Machine Maintenance Procedures 3-57
Mainboard Installation 0
Use caution when installing mainboard. Forced installation may damage left side
connectors.
Make sure all cables are clear from mainboard during installation.
1. Connect battery cable (G) to mainboard connector (g). (Figure 3-74)
2. Align and install mainboard ports (E) to lower cover slots (F) as shown in Figure 3-72.
3. Install mainboard on lower cover.
4. Install and secure screws (D) to lower cover. (Figure 3-71)
5. Connect and secure the following module cables to mainboard connectors: (Figure 3-70)
Bluetooth module cable (A) to mainboard connector (a)
USB module cable (B) to mainboard connector (b)
DT board cable (C) to mainboard connector (c)
6. Install LCD module.
ID Size Quantity Screw Type
D M2.5x3.0 2
To Next Page
Loading...
