24 Chapter 2
Swap Floppy Drive Setting to Enabled will swap floppy drive a: and
b:.
Enabled
Disabled
Boot Up Floppy Seek Setting to Enabled will make BIOS seek floppy
drive a: before booting the system.
Enabled
Disabled
Boot Up NumLock Status Sets the NumLock status when the system is
powered on. Setting to On will turn on the
NumLock key when the system is powered on.
Setting to Off will allows users to use the arrow
keys on the numeric keypad.
On
Off
Gate A20 Option This item is to set the Gate A20 status. A20
refers to the first 64KB of extended memory.
When the default value Fast is selected, the
Gate A20 is controlled by port 92 or chipset
specific method resulting in faster system
performance. When Normal is selected, A20 is
controlled by a keyboard controller or chipset
hardware.
Fast
Normal
ATA 66/100 IDE Cable Msg. This item enables or disables the display of the
ATA 66/100 IDE Cable Msg.
Enabled
Disbaled
Typematic Rate Setting This item is used to enable or disable the
typematic rate setting including Typematic Rate
and Typematic Deplay.
Enabled
Disabled
Typematic Rate After Typematic Rate Setting is enabled, this
item allows you to set the rate (characters/
second) at which at keys are accelerated.
Settings: 6,8,10,12,15,20,24 and 30.
Typematic Delay This item allows you to select the delay
between when the key was first pressed and
when the acceleration begins
Settings: 250, 500, 750 and 1000.
Security Option Specifies the type of BIOS password protection
that is implemented. Setup means that the
password prompt appears only when end users
try to run Setup. System means that a
password prompt appears every time when the
computer is powered on or when end users try
to run Setup.
Setup
System
APIC Mode This field is used to enable or disable the APIC
(Advanced Programmable Interrupt Controller).
Due to compliance with PC2001 design guide,
the system is able to run in APIC mode.
Enabling APIC mode will expand available IRQ
resources from the system.
Enabled
Disabled
OS Select For DRAM >
64MB
This item is only required if you have installed
more than 64MB of memory and you are
running the OS/2 operating system.
Non-OS2
OS2
HDD S.M.A.R.T Capability The S.M.A.R.T (Self-Monitoring, Analysis, and
Reporting Technology) system is a diagnostics
technology that monitors and predicts device
performance.
Enabled
Disabled
Video BIOS Shadow This item determines whether the BIOS will be
copied to RAM for faster execution.
Enabled
Disabled
Silent Boot Enables or disables the display of the logo
during boot.
Enabled
Disabled
Configuration Table Enables or disables the configuration table. Enabled
Disabled
Parameter Description Options
To Next Page
Loading...
