Acer Aspire V7-582 - Replacing the Thermal Module (Discrete)

3-82 Machine Maintenance Procedures
Replacing the Thermal Module (Discrete) 0
IMPORTANT:
+
Apply approved thermal grease and ensure all heat pads are in position
before replacing module.
CAUTION:
!
Use caution when applying thermal grease. Thermal grease may cause
damage to the mainboard.
The following thermal grease types are approved for use:
Silmore GP50
Honeywell
Jet Motor 7762
The following thermal pads are approved for use:
Eapus XR-PE
1. Remove all traces of thermal grease from CPU using a lint-free cloth or cotton swab
and Isopropyl Alcohol, Acetone, or other approved cleaning agent.
2. Apply small amount of thermal grease to center of CPU.
NOTE:
NOTE:
Force used during installation of thermal module is sufficient to spread grease
evenly over CPU top.
3. Place the thermal module on the mainboard (Figure 3-100).
Figure 3-100. Replacing the Thermal Module
4. Tighten five (5) captive screws (A) in numerical order from one (1) to five (5)
(Figure 3-16). Ensure the thermal module is properly aligned and seated.