Setup 6-9
Battery-low condition takes place.
• Disabled*
You cannot disable the Power management Mode parameter in
BIOS Utility if APM is installed under DOS, Windows or
Windows 95. To disable APM, type Power Off under DOS,
or disable the Power icon in the Windows Control Panel.
6.1.6 Load Default Settings
Selecting this option allows you to load all the default settings. The default
settings are the values initially stored in CMOS RAM intended to provide
high performance. If in the future, you change these settings, you can load
the default settings again by selecting this option.
When you select this option, the following prompt appears:
Load Setup Default Settings?
[Yes] [No]
Select [Yes] to load the default settings or [No] to abort the operation.
To Next Page
Loading...
