- 4 -
2. Introduction
This section contains general service information, please read through carefully. It should
be stored for easy access place for quick reference.
2.1. RoHS (2002/95/EC) Requirements
– Applied to all countries require RoHS.
The RoHS (Restriction of Hazardous Substance in Electrical and Electronic Equipment
Directive) is a legal requirement by EU (European Union) for the global electronics
industry which sold in EU and some counties also require this requirement. Any electrical
and electronics products launched in the market after June 2006 should meet this RoHS
requirements. Products launched in the market before June 2006 are not required to
compliant with RoHS parts. If the original parts are not RoHS complaints, the
replacement parts can be non ROHS complaints, but if the original parts are RoHS
compliant, the replacement parts MUST be RoHS complaints.
If the product service or maintenance require replacing any parts, please confirming the
RoHS requirement before replace them.
2.2. Safety Notice
1. Make sure your working environment is dry and clean, and meets all government
safety requirements.
2. Ensure that other persons are safe while you are servicing the product.
DO NOT perform any action that may cause a hazard to the customer or make the product
unsafe.
3. Use proper safety devices to ensure your personal safety.
4. Always use approved tools and test equipment for servicing.
5. Never assume the product’s power is disconnected from the mains power supply.
Check that it is disconnected before opening the product’s cabinet.
6. Modules containing electrical components are sensitive to electrostatic discharge
(ESD). Follow ESD safety procedures while handling these parts.
7. Some products contain more than one battery. Do not disassemble any battery, or
expose it to high temperatures such as throwing into fire, or it may explode.
8.
Refer to government requirements for battery recycling or disposal.
2.3 .Compliance Statement
Caution: This Optical Storage Product contains a Laser device. Refer to the product
specifications and your local Laser Safety Compliance Requirements.
2.4. General Descriptions
This Service Manual contains general information. There are 3 levels of service:
Level 1: Cosmetic / Appearance / Alignment Service
Level 2: Circuit Board or Standard Parts Replacement
Level 3: Component Repair to Circuit Boards
To Next Page
Loading...
