No Symptom Procedure
14 Rod Adjustment 1. Environment adjustment
- The distance between the engine and the screen is
1.7M
- This process should be done at a dark
environment.(under 10 Lux)
2. Image position adjustment
- If there are shadows at “Left” & “Right” side of the
screen, adjust
“Screw 1” to adjust ROD position.
- If there are shadows at “TOP” & “Bottom” side of the
screen, adjust
“Screw 2” to adjust ROD position.
- “Screw 1” should be adjusted rst, and then
“Screw 2”.
3. Procedure adjustment
- Change the screen to “white screen”.
- Adjust the screws by using the rod on the engine
module to readjust the image. (adjust until the yel-
lowish or bluish parts disappeared.)
Note: To avoid over adjust the rod.
After the operation,please use the mucilage to
xed the screw.
Screw 2
Screw 1
To Next Page
Loading...
