Acer P5270 - XGA DLP Projector - Default Language Reset

6-12
P5270/P5270 Refresh
Condential
6-5 Default Language Reset (For P5270 Refresh)
(1).Plug in power cord and hold on the “down” button, then press the “Power” button
Note: After about 5s, Power LED turns blue while Temp LED ashes in red for about 2s,
then release the “Down”button.
(2) After that, please check the LED status and judge the actions as the following table:
Note: if fail, please do the actions as above steps item (1)-(2)
S/N General rule:
Use the last 1 digit code (as red word) for language information
LED Status Result
Power(blue)+TEMP(red)+LAMP(red) OK
Power(blue)+TEMP(red) Fail
Language code(F) Default Language
1 English
2 Thailand
3 Japan
4 TC
5 SC
6 Russian
7 Germany
8 Hungarian