Acer P5270 - XGA DLP Projector - Waveform Download

P5270/P5270 Refresh
5-8
Condential
No Step Procedure Photo
9
1. When Firmware
Upgrade Process is
nished, the LED
power light on.
2. Unplug USB Cable
and Power Cord.
Re-plug in Power
Cable.
10 Check
Firm-
ware
Restart the unit and enter
the Service Mode.Then
choose”Information
and Reset” item to check
the Firmware
Version.
(For entering Service
Mode, please refer to
Chapter 4 Function Test
and Alignment Procedure.)
5-5 Waveform Download
1.Plug in power cord and hold on “Up” button,then press the “Power” button
Note: After about 5s, Power LED turns blue while Temp LED ashes in red for about 2s,
then release the “Up”button.
2.After that, please check the LED status and judge the actions as the following table:
LED Status Result
Power(blue)+TEMP(red)+LAMP(red) OK
Power(blue)+TEMP(red) Fail
Note: this step must be excuted after FW, Main Board and Lamper Driver changed!