6-6 Default Language Reset (For S1200)
(1) Hold on “Down” button then plug in the Power Cord.
Note: At this moment, Power LED turns blue while Temp LED ashes in red for about
4s,then release the “Down” button.
(2) After that, please check the LED status and judge the actions as the following table:
LED Status Result
Power(blue)+TEMP(red)+LAMP(red) OK
Power(blue)+TEMP(red) Fail
Note: if fail, please do the actions as above steps item (1)-(2)
S/N General rule
Use the last 1 digit code (as red word) for language information
Language code(F) Default Language
1 English
2 Thailand
3 Japan
4 TC
5 SC
6 Russian
7 Germany
8 Hungarian
To Previous Page
Loading...
