ACME DVS-5000 - Page 21

DVS-2500/5000/5000II
20B
menu mode.
BL.O. P/T Moving—Blackout while pan/tilt moving
Select BL.O. P/T Moving, press ENTER button to confirm, present mode will blink on
the display, press UP/DOWN button to select No (normal while pan/tilt moving) or Yes
(blackout while pan/tilt moving), press ENTER button to store. Press MENU button
back to the last menu or let the unit idle one minute to exit menu mode.
Sw. Source Delay—Delay while switch the sources
Select Sw. Source Delay, press ENTER button to confirm, present mode will blink on
the display, press UP/DOWN button to select from 0s (No delay) to 60s (Delay 60
seconds to show the new source output while switching sources.), press ENTER button
to store. Press MENU button back to the last menu or let the unit idle one minute to exit
menu mode.
Image Auto Inverse
Select Image Auto Inverse, press ENTER button to confirm, present mode will blink
on the display, press UP/DOWN button to select No (normal) or Yes (Image auto
inverse while the DMX value of tilt is over 128 ), press ENTER button to store. Press
MENU button back to the last menu or let the unit idle one minute to exit menu mode.
Lamp Setting
Attention: The lamp will not be on until detected temperature is lower than 45 ° C.
Enter menu mode, select Lamp Setting, press ENTER button to confirm, press
UP/DOWN button to select On/Off, State/Power on, Off Via Dmx, On if Dmx on, Off
if Dmx off, or Ignition Delay..
On/Off—Turn on/off the lamp
Select On/Off, press ENTER button to confirm, present mode will blink on the display,
press UP/DOWN button to select On (lamp on) or Off (lamp off), press ENTER button
to store. Press MENU button back to the last menu or let the unit idle one minute to exit
menu mode.
State/Power On—Lamp state while power on
Select State/Power On, press ENTER button to confirm, present mode will blink on the
display, press UP/DOWN button to select On (Lamp on while power on) or Off (Lamp