DVS-2500/5000/5000II
21B
off while power on), press ENTER button to store. Press MENU button back to the last
menu or let the unit idle one minute to exit menu mode.
Off Via Dmx—Turn off the unit via Dmx controller
Select Off Via Dmx, press ENTER button to confirm, present mode will blink on the
display, press UP/DOWN button to select Yes (Enable the function of turning off the unit
via Dmx controller) or No (Disable the function of turning off the unit via Dmx controller),
press ENTER button to store. Press MENU button back to the last menu or let the unit
idle one minute to exit menu mode.
(When you operate the unit via DMX controller, set the value of channel “special
function” to “lamp off”, waiting for 8 seconds, then the lamp will be off if you choose
“yes” mode).
On If DMX On— Lamp turns on when DMX signal is detected
Select On If Dmx On, press ENTER button to confirm, present mode will blink on the
display, press UP/DOWN button to select Yes (Lamp turns on when DMX signal is
detected) or No (Lamp off when DMX signal is detected), press ENTER button to store.
Press MENU button back to the last menu or let the unit idle one minute to exit menu
mode (If the lamp is off via DMX signal, you can reconnect the DMX controller to make
the lamp on).
Off If DMX Off— Lamp turns off when DMX signal is cut off
Select Off If Dmx Off, press ENTER button to confirm, present mode will blink on the
display, press UP/DOWN button to select Yes (Lamp turns off when DMX signal is cut
off) or No (Normal), press ENTER button to store. Press MENU button back to the last
menu or let the unit idle one minute to exit menu mode.
Ignition Delay—Delay time between power on and lamp on
Select Ignition Delay, press ENTER button to confirm, present mode will blink on the
display, press UP/DOWN button to adjust the delay time from 0S to 255S, press
ENTER button to store. Press MENU button back to the last menu or let the unit idle
one minute to exit menu mode.
Display Setting
Enter menu mode, select Display Setting, press ENTER button to confirm, press
UP/DOWN button to select Display Direction, Backlight Auto Off, Backlight
To Next Page
Loading...
