ACME DVS-5000 - Page 23

DVS-2500/5000/5000II
22B
Intensity or Temperature unit.
Display Direction
Select Display Direction, press ENTER button to confirm, present mode will blink on
the display, press UP/DOWN button to select Normal, Inverse or Auto(Adjust
automatically display direction) press ENTER button to store. Press MENU button back
to the last menu or let the unit idle one minute to exit menu mode.
Backlight Auto Off
Select Backlight Auto Off, press ENTER button to confirm, present mode will blink on
the display, press UP/DOWN button to select No (display always on) or Yes (display
goes off one minute after exiting menu mode), press ENTER button to store. Press
MENU button back to the last menu or let the unit idle one minute to exit menu mode.
Backlight Intensity
Select Backlight Intensity, press ENTER button to confirm, present mode will blink on
the display, press UP/DOWN button to adjust backlight intensity from 1 (darkest) to 10
(brightest), press ENTER button to store. Press MENU button back to the last menu or
let the unit idle one minute to exit menu mode.
Temperature Unit
Select Temperature Unit, press ENTER button to confirm, present mode will blink on
the display, press UP/DOWN button to select ℃ or ℉, press ENTER button to store.
Press MENU button back to the last menu or let the unit idle one minute to exit menu
mode.
Fixture Test
Enter menu mode, select Fixture Test, press ENTER button to confirm, press
UP/DOWN button to select Auto Test or Manual Test
Auto Test
Select Auto Test, press ENTER button to confirm, the unit will run built-in programs to
automatically test pan, tilt, shutter, focus. Press MENU button back to the last menu or
exit menu mode after auto test.
Manual Test
Select Manual Test, press ENTER button to confirm, the present channel will show on
the display, press UP/DOWN button to select channel, press ENTER button to confirm,