ACME DVS-5000 - Page 24

DVS-2500/5000/5000II
23B
then press UP/DOWN button to adjust the value, press ENTER button to store, the
fixture will run as the channel value selected. Press MENU button back to the last menu
or exit menu mode let the unit idle one minute.
(All channels value will become 0 after exiting Manual Test menu)
Fixture Information
Enter menu mode, select Fixture Information, press ENTER button to confirm, press
UP/DOWN button to select Fixture Use Time, Lamp On Time or Firmware Version.
Fixture Use Time
Select Fixture Use Time, press ENTER button to confirm, fixture used time will show
on the display, press MENU button to exit.
Lamp On Time
Select Lamp On Time, press ENTER button to confirm, lamp on time will show on the
display, press ENTER button to confirm, press UP/DOWN button to select Exit or
Reset Time, press ENTER button to confirm. Press MENU button back to the last
menu or exit menu mode let the unit idle one minute.
Exit
Select Exit, press ENTER button will back to the last menu or exit menu mode
let the unit idle one minute.
Reset Time
Select Reset Time, press ENTER button to confirm, and the lamp on time will
clear to 0.
Firmware Version
Select Firmware Version, press ENTER button to confirm, firmware version will show
on the display, press MENU button back to exit.
Reset Functions
Enter menu mode, select Reset Functions, press ENTER button to confirm, press
UP/DOWN button to select Pan&Tilt,, Shutter, Focus, or All.
Pan/Tilt—Reset Pan/Tilt
Select Pan/Tilt, press ENTER button to confirm, press UP/DOWN button to select Yes
(the unit will reset pan and tilt to their home positions) or No, press ENTER button to