ACME DVS-5000 - Page 25

DVS-2500/5000/5000II
24B
store. Press MENU button back to the last menu or let the unit idle one minute to exit
menu mode.
Shutter—Reset Shutter
Select Shutter, press ENTER button to confirm, press UP/DOWN button to select Yes
(the unit will run built-in program to reset shutter to its home positions) or No, press
ENTER button to store. Press MENU button to exit.
Focus—Reset Focus
Select Focus, press ENTER button to confirm, press UP/DOWN button to select Yes
(the unit will run built-in program to reset Focus to home positions) or No, press ENTER
button to store. Press MENU button to exit.
All—Reset All
Select All, press ENTER button to confirm, press UP/DOWN button to select Yes (the
unit will run built-in program to reset all motors to their home positions) or No, press
ENTER button to store. Press MENU button to exit.
Attention: The lamp will not be on until detected temperature is lower than 45 ° C.
Special Functions
Enter menu mode, select Special Functions, press ENTER button to confirm, press
UP/DOWN button to select Fixture Maintenance or Factory Setting.
Fixture Maintenance
Select Fixture Maintenance, press ENTER button to confirm, press UP/DOWN button
to select Interval or Remain Time.
Interval
Select Interval, press ENTER button to confirm, the interval time will show on
the display. Press MENU button to exit.
Remain Time
Select Remain Time, press ENTER button to confirm, the remaining time will
show on the display, press ENTER button to confirm, press UP/DOWN button to
select Exit or Reset time, press MENU button to exit.
Factory Setting
Select Factory Setting, press ENTER button to confirm, press UP/DOWN button to