34
Horizontal Placement
Do not discard the stand. The label with your Drive’s Model and Serial
numbers may be affixed to the underside of the stand (it may also be
affixed to the back of the Drive). In the event that you need warranty
service, you will need to send us the stand along with the Drive itself.
Removing the stand
Use a screw driver with the proper type and size head to
loosen the two screws located on the underside of the stand.
Loosen the screws just enough so that you can easily slide the
stand out of the groove. Keep the nuts attached to the screws.
Store the stand in a safe place.
To Next Page
Loading...
