Acomdata External HARD DRIVE USB 2.0 - Installing the USB 2.0 Driver

36
If you are using Windows 98SE or Windows 2000 (Service
Pack 3 or earlier) you need to install the USB 2.0 driver
on the supplied CD before connecting the Drive. Follow
the instructions below. All other users can proceed to
"Connecting the Drive to Your Computer."
1. Insert the CD into your computer's CD/DVD drive.
2. The installation program will launch automatically. Follow
the instructions in the InstallShield Wizard.
3. On the final screen of the InstallShield Wizard, you will be
given the option to restart your computer. (You must restart
your computer in order to make the software active.) Make
sure the "restart" option is selected and click Finish. Do not
remove the CD until after the computer restarts.
4. After your computer restarts, you can remove the CD.
5. Proceed to "Connecting the Drive to Your Computer."
Installing the USB 2.0 Driver