AR-B1479 User’s Guide
27
4. INSTALLATION
This chapter describes the installation procedure. The following topics are covered:
l Overview
l Utility Diskettes
4.1 OVERVIEW
This chapter provides information for you to set up a working system based on the AR-B1479 CPU board. Please
carefully read the details of the CPU board’s hardware descriptions before installation. Pay special attention to the
jumper settings, switch settings and cable connections.
Follow steps listed below for proper installation:
Step 1:
Read the CPU board’s hardware description in this manual.
Step 2:
Set jumpers.
Step 3:
Make sure that the power supply connected to your AR-B1479 CPU board is turned off.
Step 4:
Connect all necessary cables. Make sure that the HDD; serial and parallel cables are connected to
pin 1 of the related connector (not upside down).
Step 5:
Connect the hard disk fla
t cables from the CPU board to the drives. Connect a power source to
drive.
Step 6:
Plug the keyboard into the keyboard connector.
Step 7:
Turn on the power.
Step 8:
Configure your system with the BIOS Setup program (section 5) then re-boot your system.
Step 9:
If the CPU board does not work, turn off the power and read the hardware description carefully
If the CPU board still does not perform properly, return the board to your dealer for immediate
service.
4.2 UTILITY DISKETTE
The AR-B1479 provides a piece of which contains necessary drivers and utility for installing AR_B1479.
4.2.1 Driver Installation
Generally, the CD that comes with AR-B1479 should be able to carry out ‘Auto run’ function, please follows the
instruction displayed on the screen to install drives. In case, if the ‘Auto run’ function is fail, please execute
‘Setup.exe’ program under root directory of the CD.
To Next Page
