Acrosser Technology AR-B1479 - PCI;Plug and Play

AR-B1479 User’s Guide
36
Hard Disk Time Out
This option specifies the length of a period of hard disk inactivity. When this period expired, the hard disk drive
enters the power-conserving mode specified on the <Hard Disk Power Down Mode> option.
Standby Time Out
Suspend Time Out
These options specify the length of the period of system inactivity when the computer is already in Standby mode
before the computer is placed on Suspend mode. In Suspend mode, nearly all power use is curtailed.
Slow Clock Ratio
This option specifies the speed at which the system clock runs in power saving modes. The settings are
expressed as a ratio between the normal clock speed and the power down clock speed.
IRQ
These options enable event monitoring. When the computer is in a power saving mode, activity on the named
interrupt request line is monitored by BIOS. When any activity occurs, the computer enters Full On mode.
5.6 PCI/PLUG AND PLAY
This section is used to configure PCI / Plug and Play features. The <PCI & PNP Setup> option configures the PCI
bus slots. All PCI bus slots on the system use INTA#, thus all installed PCI cards must be set to this value.
AMIBIOS SETUP - PCI/PLUG AND PLAY SETUP
(C) 1998 American Megatrends, Inc. All Rights Reserved
Plug and Play Aware O/S Yes
Clear NVRAM No
PCI Latency Timer (PCI Clocks) 64
PCI IDE BusMaster Disabled
DMA Channel 0 PnP
DMA Channel 1 PnP
DMA Channel 3 PnP
DMA Channel 5 PnP
DMA Channel 6 PnP
DMA Channel 7 PnP
IRQ 3 PCI /PnP
IRQ 4 PCI /PnP
IRQ 5 PCI /PnP
IRQ 7 PCI /PnP
IRQ 9 PCI /PnP
IRQ 10 PCI
/PnP
IRQ 11 PCI
/PnP
IRQ 12 PCI
/PnP
IRQ 14 PCI
/PnP
IRQ 15 PCI
/PnP
Reserved Memory Size Disabled
Reserved Memory Address
C800
Available Options :
Yes
No
ESC:Exit ↑↓:Sel
PgUp/PgDn:Modify
F2/F3:Color
Figure 0-8 BIOS: PCI / Plug and Play Setup
Plug and Play Aware O/S
Set this option to Yes if the operating system installed in the computer is Plug and Play-aware. The BIOS only
detects and enables PnP ISA adapter cards that are required for system boot. The Windows 95 operating system
detects and enables all other PnP-aware adapter cards. Windows 95 is PnP-aware. Set this option <No> if the
operating system (such as DOS, OS/2, Windows 3.x) does not use PnP. You must set this option correctly or
PnP-aware adapter cards installed in your computer will not be configured properly.