2) To disable, select an Door 3 0 for next door
Enabled door Door Normal ✔ to disable door
1) To enable, select a Door 3 0 for next door
Disabled door Disabled ✔ to enable door
ACT1000/2000 Operating Instructions Software Version 4.00-00
18
HIGH SPEED
Communications on the controller defaults to 9600 baud. The high speed option sets the controller
to operate at 19200 baud. This option applies to direct connect to a PC, networked interface and
printer modes of operation.
SLAVE MODE (ACT2000 ONLY)
This option selects slave mode operation as part of an ACT5000pc network. While the controller
is switched into slave mode and all card events are transmitted to the network master for
validation. The controller itself will not make any decisions on card events unless it is operating
in fallback mode due to a network failure. This option is always set to No when using
ACTWinPro.
NO HIST. LOG
This option suppresses the reporting of events occurring while offline in slave mode only.
Normally when the controller is operating in slave mode, events are logged locally if the controller
is offline, and are transmitted to the PC when communications are restored.
PRINT ALL
This option selects real-time printing to an attached serial printer. Each event is time stamped and
printed immediately on the printer. Real-time printing will be temporarily suspended while a full
log printout requested from the operator menu is in progress.
REMOTE DOORS (ACT2000 ONLY)
This menu is where additional door stations or ACT1000 units are configured as extra doors on
the ACT2000 controller. The new door (Door 3 to 16) is selected using the 0 key and the current
status of the door is displayed on the bottom line of the LCD. The ✔ key may then be used to
enable or disable the door:
If a non-existent or incorrectly addressed door is enabled, the door will be polled for a short while,
then the status will be displayed as Door Offline.
SET PASSWORD
A password consisting of a 10 digit number may be programmed into the controller to prevent
unauthorized access from remote ACTWinPro users. Ensure this password matches the encryption
key used by ACTWinPro.
Card Setup
The card setup menu is used to inform the controller which cards should be recognized by the
system. Usually all that is required is to set the primary site code for the system. The site code is
supplied along with any cards ordered, or can be obtained directly from ACT. In addition, a site
code from another installation may be entered allowing shared access to the building. Where non-
standard cards are being used, possibly from a previous access control or time & attendance
system, the card format may be altered to accept these.
To Next Page
Loading...
