6 Dispensing a treatment
6.1 Accessory usage conditions
The optical guide must be cleaned and sterilised prior to use. The rigid protection shield must be cleaned and
disinfected prior to use.
The Mini LED accessories include:
l a charging base;
l an optical guide;
l a rigid protection shield.
Refer to the cleaning, disinfection and sterilisation instructions for accessories listed in the chapter Associated
documentation page 5.
6.2 First use
To prepare your Mini LED, follow the steps below:
l Clean and disinfect the rigid protection shield with an alcohol wipe.
l Clean and disinfect the handpiece with an alcohol wipe.
l Plug the charging base into the mains.
l Check that the green indicator light on the base lights up twice and listen out for a beep sound.
l Install the battery on the handpiece.
l Place the Mini LED on its charging base.
l The Mini LED is correctly installed when two beeps are heard and the green indicator light on the base starts
flashing.
l Leave the Mini LED to fully charge.
l The Mini LED is charged when the green indicator light on the base stops flashing and remains on permanently.
l Remove the protection plug from the handpiece nosepiece.
l Insert the sterilised optical guide into the handpiece nosepiece.
l You will hear a click when the optical guide is correctly inserted.
l Install the rigid protection shield.
l Wear safety goggles and protective gloves.
l Provide your patient with safety goggles.
User Manual | Mini LED™ | J02541|V8|(07)| 01/2017|NG13EN010H - Page 15/38
To Next Page
Loading...
