7 Medical device description
7.1 Light indicator
The light indicators are designed to signal the device's status.
The handpiece has four light indicators in total.
Colour Mode
Green Normal mode
Red The battery is flat
Flashing red Thermal cut-out activated
On/off light indicator
Indicator Pictogram Colour Mode
High Green Fast
Medium Green Pulsed
Low Green Progressive
Three operating mode light indicators
The charging base has two light indicators.
Colour Meaning
Flashing green - upper indicator Charging
Green - upper indicator Charge fully completed
Red - lower indicator Power measured at less than 605 mW/cm
2
and insufficient for required operation
Off - lower indicator Power measured is insufficient for required operation
Green - lower indicator Power measured equal to or greater than 785 mW/cm
2
Charging base light indicators
7.2 Mini LED™
The Mini LED can only be used with the following accessories:
l 7.5mm opalescent optical guide
l 7.5mm amber optical guide
l Mini LED titanium battery
l Mini LED handpiece
l Protection plug
l Rigid protection shield
l Charging base and mains adapter
The protection plug is designed to prevent any products from infiltrating the handpiece that may damage its
electronics, the connector or the LEDs. It must be used when cleaning the handpiece. Another plastic protective plug
protects the connectors with the battery.
7.3 Base
The Mini LED charging base comprises a power tester. This is used to test correct operation of the Mini LED.
7.4 Operating mode
Rapid mode activates maximum power of the Mini LED for ten seconds.
Pulsed mode activates maximum power of the Mini LED in ten successive bursts lasting one second, each separated by
250 ms.
Progressive mode initiates a gradual rise in power lasting ten seconds followed by ten seconds at full power.
User Manual | Mini LED™ | J02541|V8|(07)| 01/2017|NG13EN010H - Page 17/38
To Next Page
Loading...
